Specifications

ASMi-54C LRS-102 Ver. 2.0 Installing the Module 2-1
Chapter 2
Installation and Setup
This Chapter provides installation and setup instructions for ASMi-54C modules.
ASMi-54C connector pin functions and the wiring of the relevant cables are
presented in
Appendix A .
The information presented in this Chapter supplements the general LRS-102
installation, configuration and operation instructions contained in the
LRS-102
Installation and Operation Manual
.
2.1 Installing the Module
Before performing any internal settings, adjustment, maintenance, or repairs,
first disconnect all the cables from the module, and then remove the module
from the LRS-102 enclosure.
No internal settings, adjustment, maintenance, and repairs may be performed by
either the operator or the user; such activities may be performed only by a skilled
technician who is aware of the hazards involved.
Always observe standard safety precautions during installation, operation, and
maintenance of this product.
The ASMi-54C module contains components sensitive to electrostatic discharge
(ESD). To prevent ESD damage, always hold the module by its sides, and do not
touch the module components or connectors.
To prevent physical damage to the electronic components assembled on the two
sides of the module printed circuit boards (PCB) while it is inserted into its
chassis slot, support the module while sliding it into position and make sure that
its components do not touch the chassis structure, nor other modules.
ASMi-54C modules may be installed in an operating chassis (hot insertion).
ASMi-54C software can be updated by downloading from the CL module.
Therefore, if the ASMi-54C module is not yet loaded with the required software
version, refer to Appendix B of the LRS-102 Installation and Operation Manual for
detailed software downloading instructions.
Preparations for Installation
No preparations are required for ASMi-54C modules with UTP Ethernet ports,
terminated in RJ-45 connectors.
Note
Warning
Caution
Caution