Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Appendix E IR-ETH/Q Ethernet Card Installation and Operation Manual
E-2 Introduction ASMi-52CD Ver. 1.0
Physical Description
Figure E-2
shows the IR-ETH/Q Ethernet card. Four connectors are provided to
connect the Ethernet card to the top of the main module card. The IR-ETH/Q
Ethernet card contains a 6-section DIP switch.
6
5
Figure E-2. Location of DIP Switch on IR-ETH/Q Ethernet Card
DIP Switch Settings
Configure the IR-ETH/Q module by setting the DIP switch in accordance with
Table E-1
. Unlike IR-ETH module, the IR-ETH/Q Ethernet mode and filtering cannot
be controlled via the ASMi-52CD software and must be set via the SW-3 DIP
switch.
Table E-1. DIP Switch Settings
Section Number Name Description (Default setting in bold)
4 – Reserved for future use. Must always be set to OFF.
5 FD/HD ON – Ethernet bridge full duplex mode
OFF – Ethernet bridge half duplex mode
6 TRANS/FIL ON – Disables LAN filter; passes all frames transparently
OFF – Passes only frames destined for another LAN