Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Installation and Operation Manual Appendix D IR-ETH Ethernet Card
ASMi-52CD Ver. 1.0 Installation and Operation D-3
D.2 Technical Specifications
General
LAN Table
10,000 addresses
Filtering and
Forwarding
15,000 pps
Buffer
256 frames
Delay
1 frame
LAN
Standard
Conforms to IEEE 802.3/Ethernet
Data Rate
10 Mbps (20 Mbps 10BaseT FDX)
WAN
Protocol
HDLC
Data Rate
According to the modem transmission rate
Connector
RJ-45
D.3 Installation and Operation
This section describes:
• IR-ETH Ethernet card installation on the ASMi-52CD modem module
• LRSI-F-14 interface module installation in the LRS-24 hub
For hub installation and operation of the ASMi-52CD module, see
Chapter 2
.
The ASMi-52CD and IR-ETH cards contain components sensitive to electrostatic
discharge (ESD). To prevent ESD damage, do not touch the module components
or connectors.
Installing IR-ETH Card
To install the Ethernet card:
1. Set the DIP switch on the IR-ETH Ethernet card according to
Table D-1
.
2. Press the IR-ETH Ethernet card (with connectors facing down) against the
ASMi-52CD module connectors.
Caution