Specifications

Installation and Operation Manual Appendix C List of Parameters
ASMi-52CD Ver. 1.0 Displaying Modem Status C-9
C.3 Displaying Modem Status
 To display the modem status:
1. From the Main menu, select Modem Status.
2. Select the ASMi-52CD slot.
The Modem Status screen appears (see
Figure C-5 ). The Modem Status
screen provides information on the system interfaces and front panel LED
status.
Table C-5 explains the parameters on this screen.
3. To display the second page of parameters, move the cursor to NEXT
PARMETERS field by pressing <Tab> and select YES by pressing <f> or <b>.
The second page of the Modem Status screen appears (see
Figure C-6 ).
Table C-6 explains the parameters on this screen.
MODEM STATUS
MODEM NAME:ASMi-52CD
DEFINE MODEM PORT NUMBER: 1
SELECT MODEM : MODEM 1 LOCAL REMOTE MODEM : NULL
INTERFACE MODULE : LRSI-F-14 REMOTE SLOT : N/A
MODEM PORT : ETHERNET REMOTE MODEM LINE CONNECTOR:TERM.BLOCK
SW VERSION : 0.2E1 REMOTE MODEM FRONT PANEL : N/A
HW VERSION : 00 .00 HW PANEL VERSION : 03
LED STATUS: 1)RTS: OFF 2)DCD: OFF 3)TEST: OFF 4)ERR: ON
5)ELE-LOW: ON 6)ELE-AIS: OFF 7)OPT-LOW: OFF 8)OPT-AIS: OFF
LINK QUALITY : N/A PS PHANTOM STATUS : N/A
BPV ERROR : N/A CHASSIS : N/A
FIBER OPTIC ERROR : N/A WAVE LENGTH : 850
LINE UTILITY : 01 %
BERT RUN TIME : 0 BERT ERR SECONDS : 0
BERT SYNC LOSS : 0 BERT PRE FEC : 0
BERT POST FEC : 0
NEXT PARAMETERS : NO
Figure C-5. Modem Status Screen
Bolded rows in Figure C-5 indicate parameters applicable to ASMi-52CD.
Non-bolded parameters listed on a screen to other modems installed in the
LRS-24 chassis.
The Modem Status parameters and values are explained in
Table C-5 .