Specifications

Installation and Operation Manual Appendix C List of Parameters
ASMi-52CD Ver. 1.0 Configure Transmission Parameters C-3
Bolded rows in Figure C-2 indicate parameters applicable to ASMi-52CD.
Non-bolded parameters listed on a screen apply to other modems installed in
the LRS-24 chassis.
4. Configure the E1 parameters by moving the cursor to NEXT PARMETERS (E1)
field by pressing <Tab>, select YES by pressing <f> or <b>, and pressing
<Tab> again.
The Modem Setup Menu: E1 Parameters screen appears (see
Figure C-3 ).
Table C-3 explains the parameters on this screen.
5. Configure the SHDSL line parameters by moving the cursor to NEXT
PARMETERS (LINE) field by pressing <Tab>, select YES by pressing <f> or <b>,
and pressing <Tab> again.
The Modem Setup Menu: Line Parameters screen appears (see
Figure C-
4
). Table C-4 explains the parameters on this screen.
MODEM SETUP
MODEM NAME: ASMi-52CD
DEFINE MODEM PORT NUMBER : 1
MODEM STATUS : MASTER PERMANENT
SELECT MODEM : MODEM 1 LOCAL
SYNC/ASYNC : N/A CHARACTER LENGTH : N/A
NO. STOP BIT : N/A DATA RATE : 128K
PARITY : N/A CD SENSE : N/A
CLOCK SOURCE LOC/REM : INTERNAL EXT SOURCE:Modem #1 PORT : N/A
INTERFACE : N/A RTS/CTS DELAY (0:255 : N/A)
RTS TO DCD : N/A DTR TO DSR : N/A
OUTPUT LEVEL : N/A INPUT LEVEL : N/A
OUTPUT IMPEDANCE : N/A ohm INPUT IMPEDANCE : N/A ohm
CARRIER CONTROL : N/A ERROR CORRECTION : N/A
RATE ADAPTATION METHOD : N/A AIS : N/A
LINE CODING : N/A PHANTOM : N/A
T1 LINE LENGTH : N/A
BRIDGING : N/A ETHERNET MODE : HALF-DUP
MASK SIGNAL STATUS : DATA: NO RTS : NO TD : NO RD: NO
DCD : NO TEST: NO ERR: NO SQ: NO
NEXT PARAMETERS(E1) : NO NEXT PARAMETERS(LINE) :NO
Figure C-2. Modem Setup Menu