Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Appendix A Pinouts Installation and Operation Manual
A-6 Adapter Cable for Unbalanced E1 Interface ASMi-52CD Ver. 1.0
A.6 Adapter Cable for Unbalanced E1 Interface
When using an unbalanced E1 interface, use the CBL-LRSI25/DB25/UB adapter
cable for connecting two BNC unbalanced ports to the DB-25 connector of the
LRSI-F-25 interface module. The CBL-LRSI25/DB25/UB cable includes one male
DB-25 and four BNC connectors.
CH1-RX
CH1-TX
CH2-RX
CH2-TX
Figure A-6. CBL-LRSI25/DB25/UB Cable
Table A-6. CBL-LRSI25/DB25/UB Cable Pinout
Function DB-25 BNC
23 CH1-RX 1
RX
11 CH1-RX 2
24 CH1-TX 1
CH-1
TX
12 CH1-TX 2
20 CH2-RX 1
RX
8 CH2-RX 2
21 CH2-TX 1
CH-2
TX
9 CH2-TX 2