Specifications

Chapter 4 Configuration Installation and Operation Manual
4-4 Configuring the Modem ASMi-52CD Ver. 1.0
Setup to switch control or to load configurable parameters
from one modem to the other
Modem Parameters Modem Setup Configuring parameters of both modems
Modem Status Modem Status Viewing types of both digital and line interfaces and
LED indications, also the modem’s current software
and hardware version.
Modem Log-file Modem Log File Viewing a list of timed events for the local and
remote modems
Modem Diagnostic Modem Diagnostic Invoking loopback connections, and LEDs test
Modem Alarm Modem Alarm
Status
Viewing modem alarm messages and states
4.4 Configuring the Modem
The initial configuration of the ASMi-52CD modem includes the following steps:
1. Accessing the Modem Setup menu.
2. Configuring the clock source.
3. Configuring the DTE interface:
 Serial interface: Configure the data rate
 E1 interface: Go to the Modem Setup menu: E1 Parameters menu and
configure the E1 parameters
4. Configuring the line parameters: Go to the Modem Setup Menu: Line
Parameters screen and configure the line parameters
The instructions given below cover only the initial configuration procedure. Refer
to
Appendix C for the detailed descriptions of ASMi-52CD commands.
 To access the Modem Setup menu:
1. In the Main menu, select Modem Parameters.
The following message appears:
Please enter the slot number (1-12)
2. Type the slot number of the ASMi-52CD card and press <Enter>.
The Modem Setup menu appears.
Configuring the Clock Source
 To configure the clock source:
• In the Modem Setup menu, move the cursor to CLOCK SOURCE LOC/REM field
by pressing <Tab> and select the clock source for the selected modem.