Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Chapter 4 Configuration Installation and Operation Manual
4-2 Initiating an ASCII Terminal Session ASMi-52CD Ver. 1.0
Table 4-1. LRS-24 Screens
Screen Indication
LRS-24 Cards Slot number in chassis where a modem is installed and type of
SNMP management associated with the module, via either on-board
agent (SMOD) or CM-2 agent (IMOD). ASMi-52CD is IMOD type
modem.
Hub Alarm Activity status of alarms for modems installed in chassis.
To view the active alarm associated with a specific modem, enter
the Modem Alarms Status screen. For details regarding the
ASMi-52CD alarms, refer to in Chapter 4.
Hub Log File Time and date of changes in chassis status, such as modem removal
from or insertion to chassis.
4.2 Initiating an ASCII Terminal Session
To enable an ASCII terminal session:
1. Connect the terminal to the CM-2 RS-232 front connector of the LRS-24
chassis.
2. Power up the hub.
The LRS-24 Main menu appears (see
Figure 4-1
). You are prompted for a
password.
3. If a password has been assigned, type the password and press <Enter>.
If no password has been assigned (default), press <Enter>.
The CM2> prompt appears.
To select an option in the Main menu:
1. Type the number corresponding to the option and press <Enter>.
The following message appears:
Please enter the slot number (1-12)
2. Type the slot number of the ASMi-52CD card and press <Enter>.
The screen for the selected command option appears.