Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
ASMi-52CD Ver. 1.0 Configuring for Management 4-1
Chapter 4
Configuration
This chapter describes how to configure the ASMi-52CD modem installed in the
LRS-24 hub using an ASCII terminal. It includes sections on:
• Initiating an ASCII terminal session
• Selecting command options
• Configuring the modem.
4.1 Configuring for Management
The terminal is used to configure, monitor and perform diagnostic tests of the
LRS-24 chassis and modems installed in it. Specific screens are used for each of
these management operations.
The ASCII terminal operations for the LRS-24 hub are described in the LRS-24
installation and operation manual. That manual provides instructions for:
• Accessing various terminal screens
• Selecting control parameter options
• LRS-24 management operations
The LRS-24 management screens available through the ASCII terminal handle the
hub functions for:
• IP management network
• LRS-24 chassis status
The LRS-24 hub screens also provide information on modems installed in the
chassis and their alarm status (see
Table 4-1
).
For SNMP RADview operation, refer to RADview Operation Manual.
Note