Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Chapter 3 Operation Installation and Operation Manual
3-4 Turning Off ASMi-52CD Ver. 1.0
Normal Indications
After power-up the LEDs should assume the states as shown in
Table 3-3
.
Table 3-3. Normal State of LEDs
ID Color State
POWER Green ON
DATA Yellow Blinking
TST Red OFF
ALM Red OFF
SYNC Green/Red ON (green)
3.3 Turning Off
To turn off ASMi-52CD:
• Turn off the LRS-24 chassis.