Specifications

ASMi-52CD Ver. 1.0 Controls and Indicators 3-1
Chapter 3
Operation
This chapter describes how to configure the ASMi-52CD modem installed in the
LRS-24 hub using an ASCII terminal. It includes sections on:
• Initiating an ASCII terminal session
• Selecting command options
• Configuring the modem.
3.1 Turning On
 To turn on ASMi-52CD:
1. Turn on the LRS-24 chassis and the modem on the far end of the line.
2. After power-up, all LEDs turn on for 3 seconds while the CPU initiates the
ASMi-52CD module.
3. After synchronization between the two modems has been achieved, the
ASMi-52CD module assumes the normal state according to the LED
indications in
Table 3-3 .
4. For other LED indications, see
Table 3-1 .
5. For troubleshooting, see
Using LEDs in Chapter 4.
3.2 Controls and Indicators
ASMi-52CD 2-Wire
Figure 3-1 shows the front panel of the ASMi-52CD 2-wire module. Table 3-1 lists
the functions of the ASMi-52CD front panel indicators.