Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Chapter 2 Installation and Setup Installation and Operation Manual
2-10 Connecting the Interface Cables ASMi-52CD Ver. 1.0
Connecting the LRSI-F-23 Interface
1
2
IP-1
IP-2
LRSI-F-23
L
I
N
E
Figure 2-8. LRSI-F-23
To connect the LRSI-F-23 interface module:
1. Connect the SHDSL cables terminated in RJ-45 connectors into the card
connectors marked LINE.
2. Connect RJ-45 terminated cables into the card connectors marked IP.