Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Chapter 2 Installation and Setup Installation and Operation Manual
2-8 Connecting the Interface Cables ASMi-52CD Ver. 1.0
Connecting the LRSI-F-5 Interface
LRSI-F-5
L
I
N
E
1
2
DCE-1 DCE-2
Figure 2-6. LRSI-F-5
To connect the LRSI-F-5 interface module:
1. Connect the SHDSL cables terminated in RJ-45 connectors into the card
connectors marked LINE.
2. Connect 26-pin SCSI adapter cables into the card connectors marked DCE.
Depending on the interface, use the following cables available from RAD:
Table 2-3. LRSI-F-18 Interface Adapter Cables
DCE Interface Type Cable Number Terminating Connectors
RS-530 CBL-SCS26/530/F 1 female DB-25 RS-530
V.35 CBL-SCS26/V35/F 1 female 34-pin V.35
X.21 CBL-SCS26/X21/F 1 female DB-15 X.21