Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Chapter 2 Installation and Setup Installation and Operation Manual
2-6 Interface Module Installation ASMi-52CD Ver. 1.0
Setting the Serial Interface Type (LRSI-F-5)
When using a serial interface (V.35, X.21, RS-530), use the LRSI-F-5 interface
module, you must specify the interface type by setting the jumpers on the
interface module (see
Figure 2-5
).
Both DTEs must be set for the same interface.
DTE Settings
X.21, RS.530
DTE1
P1
P2
P3
DTE2
P4
P5
P6
DTE1
P1
P2
P3
DTE2
P4
P5
P6
V.35
P1
P4
P2
P5
P3
P6
DTE1
J5
DTE2
F1
F2
F3
F4
F5
F6
F7
F8
Figure 2-5. LRSI-F-5 Interface Module PCB Layout
Installing the Interface Module into the Chassis
To install the interface module into the LRS-24 chassis:
1. Insert the interface module into the upper section above the ASMi-52CD
module of the LRS-24F chassis, or back section of the LRS-24B chassis.
2. Fasten two front panel screws to secure the module to the LRS-24 frame for
proper grounding.
Note