Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Chapter 2 Installation and Setup Installation and Operation Manual
2-2 Setting the Internal Jumpers ASMi-52CD Ver. 1.0
2.2 Package Contents
The ASMi-52CD package includes the following items:
• ASMi-52CD modem card
• Matching interface module
• Technical documentation CD
• Interface cable for connecting an interface module to the appropriate DTE:
RS-530 – CBL-SCS26/530 (if ordered)
V.35 – CBL-SCS26/V35 (if ordered)
X.21 – CBL-SCS26/X21 (if ordered)
Unbalanced G.704 E1 – CBL-LRSI25/DB25/UB (if ordered).
2.3 Setting the Internal Jumpers
Figure 2-1
illustrates the basic ASMi-52CD module layout.
J7
J3
J6
GND-FGND
N Y
POWER
DATA
ALM
SYNC
TST
JP2
U8
SHDSL Board
DTE Board
DTE Board
WD
1
JP1
Figure 2-1. ASMi-52CD Jumpers
Check that the following jumpers have been set properly:
• The JP8 jumper cap is installed over pin 1.
• The JP10 jumper is set to Y.