Specifications

Quick Start Guide Installation and Operation Manual
2 Configuring ASMi-52CD ASMi-52CD Ver. 1.0
Configuring the Clock Source
 To configure the clock source:
• In the Modem Setup menu, move the cursor to CLOCK SOURCE LOC/REM field
by pressing <Tab> and select the clock source for the selected modem by
pressing <f> or <b>.
Configuring the DTE Interface
If the ASMi-52CD includes a serial or E1 DTE interface, configure the appropriate
parameters.
Configuring the Serial Interface
 To configure the serial interface:
• In the Modem Setup menu, move the cursor to DATA RATE field by pressing
<Tab> and select the desired transmission rate by pressing <f> or <b>.
Configuring the E1 Interface
 To configure the E1 parameters:
1. In the Modem Setup menu, move the cursor to NEXT PARMETERS (E1) field by
pressing <Tab> and select YES by pressing <f> or <b>.
The Modem Setup menu: E1 Parameters screen appears.
2. Configure the following E1 parameters:
 Framing mode
 Sync (sync loss recovery time)
 CRC4 error checking
 Idle code
 E1 timeslots: Assign each E1 timeslot to carry data or idle code.
• Timeslot 0 may be looped or transparent.
• When operating with G732S framing, timeslot 0 is always transparent and
timeslot 16 is always connected.
• When operating opposite ASMi-52CD with V.35 interface, assign at least six
timeslots, including timeslot 0 to carry data.
Configuring the Line Parameters
 To configure the line parameters:
1. If you have configured E1 parameters, press <ESC> to return to the main
menu, and then repeat the steps above to access the Modem Setup menu.
2. In the Modem Setup menu, move the cursor to NEXT PARMETERS (LINE) field
by pressing <Tab> and select YES by pressing <f> or <b>.
Note