Specifications

Installation and Operation Manual Appendix G IR-IP Interface Card
ASMi-52CD Ver. 1.0 Quick Setup Menu G-11
G.7 Quick Setup Menu
The Quick Setup menu is used to select the main parameters’ values that must be
defined before you start using IR-IP.
Use the Advanced Setup menu (see the
Advanced Setup Menu section below) to
specify values for other IR-IP configuration parameters not included in this menu.
 To access the Quick Setup menu:
• From the Main menu, type 1.
The Quick Setup menu appears (
Figure G-6 ).
IR_IP <IR-IP> S/W Ver. 1.21
(date)
Quick Setup
=====================================================================
1. LAN IP Address :192.168.100.001
2. LAN IP Mask :255.255.255.000
3. WAN IP Address (empty for unnumbered) :...............
4. WAN IP Mask (empty for unnumbered) :...............
5. Default Gateway (empty - WAN interface) :...............
6. DHCP Server IP address (empty for relay disabled) :...............
7. Read Protocol From DIP Switches :[ Yes ]
8. Protocol :[ Frame Relay ]
Press one of the numbers to select or ESC:
Figure G-6. Quick Setup Menu
LAN IP Address
Used to enter the IP address for the IP router LAN interface. This is the address
to which nodes connected to the local LAN send packets addressed to the WAN.
LAN IP Mask
Used to enter the IP subnet mask. The IP router supports a maximum of 254
hosts on the LAN, therefore you must use Class C subnet masks. The basic
subnet IP mask for Class C addresses, which supports the maximum possible
number of hosts, 254, is 255.255.255.0. To help you understand the selection of
IP subnet masks,
Figure G-7 provides a configuration example for a LAN with 6
nodes: the IP subnet mask for a 6-node IP network is 255.255.255.248.