Specifications

Appendix G IR-IP Interface Card Installation and Operation Manual
G-8 Performing Preliminary Configuration ASMi-52CD Ver. 1.0
Outline of Preliminary Configuration
 To perform the preliminary configuration procedure:
1. Connect the Telnet host to the LRSI-F-23 interface module.
2. Configure the Telnet host to enable communication with the IR-IP using the
default IP parameters.
3. Establish communication with IR-IP and assign the prescribed IP address to its
LAN interface.
4. Establish again communication with IR-IP and continue the preliminary
configuration in accordance with the
Quick Setup Menu section below.
Connecting the Telnet Host
Before starting the management and configuration activities, it is necessary to
establish IP communication between your Telnet host and the IR-IP. For this
purpose, it is necessary to provide a communication path.
Because of the method used to assign an IP address to IR-IP Ethernet port, it is
recommended to connect the Telnet host directly to the LRSI-F-23 10BASE-T
connector. This is made by connecting an Ethernet cross cable between the
Ethernet connector of the Telnet host and the IP-1 (IP-2) connector.
However, you may also connect through a common LAN: in this case, connect
your Telnet host and LRSI-F-23 to Ethernet hub ports using straight cables.
Preliminary Telnet Host Configuration
If you prefer to use the factory-default parameters to establish IP communication
between your Telnet host and IR-IP, configure the Telnet host as follows:
1. Temporarily configure the host IP address as 192.168.205.2.
2. The initial destination IP address to be used by the host is 192.168.205.1.
The first step in the preliminary configuration process is to assign the desired IP
address to the LAN interface of the IR-IP interface module.
After an IP address is assigned and saved, you must change the destination IP
address of the Telnet host to the new address, otherwise it is not possible to
continue the configuration process. At the same time, you can also change the
temporary IP address assigned to the host (192.168.205.2) back to its
permanent address.
What to Do If ...
 The LINK indicator does not light immediately after ASMi-52CD is turned on
IR-IP does not receive power from ASMi-52CD. Service is required.
 The ACT indicator does not light, and there is no response from IR-IP
No software loaded into IR-IP. Download software using the procedure described
in the
New Software Download Menu section below.
Note