Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter

Appendix G IR-IP Interface Card Installation and Operation Manual
G-2 Introduction ASMi-52CD Ver. 1.0
Application
Figure G-1
shows a typical application of the ASMi-52CD modem equipped with
the IR-IP card.
LRS-24
ASMi-52CD
with IR-IP
2-wire
2-wire
Telnet Host
RADview
Management
Station
ASMi-52
with V.35 Interface
ASMi-52
with V.35 Interface
Router
Router
LRSI-F-23
Interface Module
Figure G-1. Typical Application of the ASMi-52CD Unit with IR-IP
Physical Description
The IR-IP Ethernet card (see
Figure G-2
) is mounted on top of the ASMi-52CD
main board. It contains a 6-section DIP switch described below.
3
5
4
2
Figure G-2. IR-IP DIP Switch