Specifications

Installation and Operation Manual Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
ASMi-52CD Ver. 1.0 Installation and Operation F-7
Fault Propagation
IR-ETH/QN has a fault propagation option. This feature propagates the line
interface side error conditions to the Ethernet port.
Fault propagation disables the Ethernet interface link when a control signal is not
received from the line interface. The signal causes the Ethernet interface link to
fall hence loosing the Ethernet interface link integrity.
Configuring Fault Propagation
 To enable or disable fault propagation:
1. Go to the Modem Setup window in the terminal screen.
3. Select FAULT ETH INDICATION and set to Yes or No.
MODEM SETUP
____________________________
MODEM NAME : ASMI-52CD-ETH
DEFINE MODEM PORT NUMBER : 1
MODEM STATUS : MASTER PERMANENT
SELECT MODEM : MODEM 1 LOCAL
SYNC/ASYNC : N/A CHARACTER LENGTH :N/A
No. STOP BIT : N/A DATA RATE :1792K
PARITY : N/A CD SENSE :N/A
CLOCK SOURCE LOC/REM : SYS EXT SOURCE :Modem #1 PORT :N/A
INTERFACE : N/A RTS/CTS DELAY (0:255) :N/A
RTS TO DCD : N/A DTR TO DSR :N/A
OUTPUT LEVEL : N/A INPUT LEVEL :N/A
OUTPUT IMPEDANCE : N/A ohm INPUT IMPEDANCE :N/A ohm
CARRIER CONTROL : N/A ERROR CORRECTION :N/A
RATE ADAPATION METHOD : N/A AIS :N/A
LINE CODING : N/A PHANTOM :N/A
T1 LINE LENGTH : N/A FAULT ETH INDICATION :YES
BRIDGING : N/A ETHERNET MODE :N/A
MASK SIGNAL STATUS : N/A DATA:NO RTS :NO TD :NO RD:NO
DCD :NO TEST:NO ERR:NO SQ:NO LOS:NO
NEXT PARAMETERS(E1): NO NEXT PARAMETERS(LINE): NO
Figure F-5. Modem Setup (Fault Propagation) Screen