Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Installation and Operation Manual Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
ASMi-52CD Ver. 1.0 Installation and Operation F-5
Installing IR-ETH/QN Card
To install the IR-ETH/QN card:
1. Press the IR-ETH/QN Ethernet card (with connectors facing down) against the
ASMi-52CD module connectors.
2. Fasten IR-ETH/QN to the modem.
Installing the Interface Module
Check that the LRSI-F-14 interface module (or LRSI-B-14), shown in
Figure F-3,
was supplied. The fuses are shown in
Figure F-4
.
1
2
DCE-1
DCE-2
LRSI-F-14
L
I
N
E
ACT
INT
Figure F-3. LRSI-F-14 Front Panel
F3
F4
F5
F6
Line Connectors
Backplane Connector
Ethernet Connectors
F1 F2
F8
F7
Figure F-4. LRSI-F-14 Interface Module Fuses