Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Installation and Operation Manual Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
ASMi-52CD Ver. 1.0 Installation and Operation F-3
WAN
Protocol
HDLC
Data Rate
According to the modem transmission rate
F.4 Installation and Operation
This section describes:
• Setting the IR-ETH/QN DIP switches
• Installing the IR-ETH/QN board on the ASMi-52CD modem
• Installing LRSI-F-14 interface module.
Configuring IR-ETH/QN
Configure the IR-ETH/QN module by setting the DIP switches SW1 and SW2 in
accordance with
Figure F-2, Table F-1
and
Table F-2
.
To make the changes effective, you must remove the ASMi-52CD module from
the LRS-24 chassis and insert it back again.
SW2
ON
5.
6.
4.
3.
2.
A
N
FDX
BPR
MUL
NC
1. 100
SW1
5.
7.
6.
8.
4.
3.
2. LC1
LC2
FLC
NC
NC
NC
NC
1. MDI
ON
Figure F-2. DIP Switch Locations on the IR-ETH/QN Module
Note