Specifications
Table Of Contents
- Front Matter
- Quick Start Guide
- Contents
- Chapter 1 Introduction
- Chapter 2 Installation and Setup
- Chapter 3 Operation
- Chapter 4 Configuration
- Chapter 5 Troubleshooting and Diagnostics
- Appendix A Pinouts
- Appendix B Memory and Download
- Appendix C List of Parameters
- Appendix D IR-ETH Ethernet Card
- Appendix E IR-ETH/Q Ethernet Card
- Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card
- Appendix G IR-IP Interface Card
- G.1 Introduction
- G.2 Technical Specifications
- G.3 Installation and Operation
- G.4 IR-IP Management Subsystem, General
- G.5 Performing Preliminary Configuration
- G.6 IR-IP Management Utility
- G.7 Quick Setup Menu
- G.8 Management Access Menu
- G.9 Advanced Setup Menu
- G.10 Device Control Menu
- G.11 View Menu
- G.12 Diagnostic Tool (Ping Terminal) Menu
- Back Matter
Appendix F IR-ETH/QN Ethernet/Fast Ethernet Card Installation and Operation Manual
F-2 Technical Specifications ASMi-52CD Ver. 1.0
F.2 Application
Figure F-1
shows a typical application of ASMi-52CD operating opposite two
remote ASMi-52 modems connected to the 100BaseT LANs.
ASMi-52
ASMi-52
LRS-24
ASMi-52CD
2-wire
2-wire
RADview
Management
Station
Local Loop
Customer PremisesCentral Office
Figure F-1. Typical Application of ASMi-52CD with IR-ETH/QN
F.3 Technical Specifications
Bridge
LAN Table
1,024 MAC addresses
Aging
5 minute, automatic
Filtering and
Forwarding Rate
150,000 packets per second
Buffer Size
85 frames
Delay
1 frame
LAN
Standard
IEEE 802.3/Ethernet V.2 (relevant parts), IEEE 802.1q
(relevant parts), 802.1p, 802.3x
Data Rate
• 10BaseT: 10 Mbps (20 Mbps in full-duplex)
• 100BaseT: 100 Mbps (200 Mbps in full-duplex)
Line Code
• 10BaseT: Manchester
• 100BaseT: MLT3
Connector
Shielded RJ-45 socket