Tus neeg siv phau ntawv

B-RAD Select
USER MANUAL
New World Technologies Inc. Page 13
V2022.06.20
3. INTERFACE AND SETTINGS
3.1 Changing Torque
CAUTION!
The B-RAD Select must be calibrated before use. If the LED Display shows anything other than the Torque
Select screen, the Information Menu, or the Calibration Menu, contact New World Technologies Inc. Technical
Support (refer to Section 7 – Contact Us) or your RAD Distributor.
When the B-RAD Select is powered on, the LED Display will start in Torque
Select Mode (Figure 3.1-1).
Note: If the tool has just been calibrated, the LED Display will show the tool’s rated
minimum torque.
When N·m (metric) units are used, the “N·m” indicator will light on the
keypad. When ft·lb (imperial) units are used, the “ft·lb” indicator will light.
(Refer to Section 3.2.1 – Change the Torque Units)
Figure 3.1-1: Torque Mode Display
To change the torque value:
1. Press and hold a button until a digit starts blinking. The (minus) button starts the left-most digit blinking.
If you press and hold the button again, the selected digit moves to the right. The opposite happens with
the (plus) button.
2. Press the or button quickly to change the digits by one unit at a time. Other digits may be selected
(see Step 1) to fine-tune the torque setting.
3. The selected torque value will be saved and ready after 5 seconds. Alternatively, press and hold button
until the digit stops flashing. The display will blink, indicating that the value is saved. The torque value will
be saved even when the battery is removed.
Table Mode:
The torque may be set in discrete levels from 1 to 50 over the calibrated range instead of using torque units
(see Section 3.4 – Unlock Levels for the feature code). Setting 1 is the minimum calibrated torque, setting 50
is the maximum calibrated torque, and the points in between are evenly spaced over the tool’s range. When
Table Mode is entered, the previous calibrated torque value is converted into the corresponding Table value.
3.2 Information Menu
The Information Menu allows you to change torque units, view the battery voltage, change LED brightness,
enter an unlock code, and view the program version. The menu items are described below.
To enter the Information Menu:
 While in Torque Select mode, hold the button and momentarily press the button.
 To move to the next item, hold the button and press the button. To go to a previous menu item, hold
the button and press the button.
 To exit the menu, hold both buttons until the Torque Value is displayed. If an unlock code was entered,
the locked or unlock mode will be displayed on the LEDs before the menu exits (see Section 3.4 – Unlock
Levels for a list of codes).