Tus neeg siv phau ntawv

B-RAD Select
USER MANUAL
Page 10 New World Technologies Inc.
V2022.06.20
1. Trigger Switch – tool activation
2. Forward/Reverse Switch – controls direction of
rotation: fully to the left is Forward; fully to the
right is Reverse
3. LED Display and / Button Module
4. RAD Li-Ion Battery Pack – refer to Section 2.3
– RAD Li-Ion Battery Pack
5. Battery Release Button – refer to Section 2.3.1
– Insert/Remove the RAD Li-Ion Battery Pack
Figure 2.1-1: B-RAD Select and LED Display
2.1.1 Trigger Lock
The Trigger Lock is useful while transporting or storing the B-RAD. The Trigger Lock disables the use of the
On/Off Trigger, therefore disabling the tool. It is suggested that while the B-RAD is not in use, the Trigger Lock
should be enabled.
To enable the Trigger Lock:
 Slide the Forward/Reverse Switch to the Centre Position (neither fully to the right nor fully to the left).
Note: The On/Off Trigger cannot be pressed.
To disable the Trigger Lock:
 Slide the Forward/Reverse Switch to the Forward Position or the Reverse Position.
Note: The On/Off Trigger can be pressed.
2.2 LED Display Module
The LED Display and the Buttons are the interface for the B-RAD
Select (See Figure 2.2-1). The LED Display has 4 digits that
display torque values and menu options. The (plus, increase)
and (minus, decrease) buttons are used to modify numbers
and navigate the various menus in the module. The interface is
described in detail in Section 3 – Interface and Settings.
To turn on the LED Display, attach the RAD Li-Ion Battery to
the B-RAD Select handle and press the Trigger Switch
momentarily. The Display will light a small LED indicator near
each button when a button is being pushed or held down.
The Display will dim after 15 seconds of inactivity. Lightly pull
the trigger or press a button to brighten the display. The display
will turn off after 30 seconds. To turn it back on, lightly pull the
trigger.
Figure 2.2-1: LED Display
CAUTION!
The LED Display Module may be damaged by mechanical shock, electrostatic discharge, excessive force,
moisture, or extreme temperatures. Avoid such conditions and gently wipe clean or let dry before use.
3
1
4
5
2
Plus
Button
Minus
Button
LED
Display
Units