Tus neeg siv phau ntawv

B-RAD Select
USER MANUAL
New World Technologies Inc. Page 9
V2022.06.20
Vibration (all tool models) Does not exceed 2.5 m/s
2
Noise Level (all tool models) 90 ± 2 dB
Table 1.2.1-2: Tool Operation Specifications
1.2.2 Battery Specifications
Ensure that all Battery Specifications are followed when using the B-RAD Tool System.
Battery Output
Voltage 18 VDC
Current 30 A
Charge Time 60 minutes
Charger Voltage
Input 115 or 230 VAC
Output 12 – 18 VDC
Charger Output Current 2.5 A
Table 1.2.2: Battery Specifications
1.2.3 Environmental Specifications
CAUTION!
Only operate the B-RAD Tool System if the following storage and operation conditions have been met.
Temperature Ranges  C  F
Operating Temperature 0 – 35 32 – 95
Charging Temperature 0 – 50 32 – 122
Storage Temperature -25 – 70 -13 – 158
Humidity 10% to 90% non-condensing
Shock 10G according to DIN IEC 68-2-6/29
Vibration 1G, 10-150Hz according to DIN IEC 68-2-6/29
Required Operating Conditions Non explosive atmosphere
Dry location
Table 1.2.3: Environmental Specifications
1.2.4 Cycle of Operation
A Cycle of Operation or a Tool Cycle as used in this manual is defined as:
 5 seconds forward
 10 seconds rest
Or:
 5 seconds reverse
 10 seconds rest
Note: An actual Torque Cycle may vary from the general definition above.
2. TOOL SYSTEM
The following sections introduce the operation of the Tool Handle, LED Display Interface, RAD Li-Ion Battery
Pack, and RAD Battery Charger.
2.1 Tool Handle
The B-RAD Select (Figure 2.1-1) is activated with a Trigger Switch. The Forward/Reverse Switch controls the
direction of rotation. Torque values and tool information are displayed on the 4-digit LED display. Two buttons
are used to enter the desired torque setting and view the menus. The RAD Li-Ion Battery Pack is attached to
the bottom of the Tool Handle.