System information

Chapter 6 Performance Management User’s Manual
6-2 Setting the Polling Interval Vmux-210 Ver. 1.0
6.2 Setting the Polling Interval
Use the Statistics > Polling Interval command to enable polling and set the
interval between polling attempts. Statistics windows (other than Interval
Statistics) are refreshed periodically, according to the Polling Interval, or
manually, whenever you click the <Poll> button.
 To configure the polling interval:
1. In Agent mode, select a port.
2. From the Statistics menu, select Polling Interval.
3. In the Polling Interval field, select the desired value.
4. Check Polling Enable to enable polling (for E1 or T1 ports only).
5. Click <Set>.
Figure 6-1. Polling Interval Dialog Box
Table 6-1. Polling Interval Parameters
Parameter Possible Values / Remarks
Polling Interval
(sec)
Time between polling attempts
5… 60 (in steps of 5)
Default: 10
[Set] Click <Set> to save polling interval settings
[Cancel] Click <Cancel> to close the Polling Interval dialog box without saving changes