System information

Chapter 4 Configuring a Typical Application User's Manual
4-4 Configuring the Network Management Station Vmux-210 Ver. 1.0
4.2 Connecting the Vmux Units to the Network
Management Station
Vmux units can be managed by a Network Management Station (NMS) that is
located on the LAN (hub or switch) connected to the one of the unit’s Ethernet
network (ETH-NET) ports. Install the physical devices and connect their cables,
according to the network diagram in
Figure 4-1 .
 To connect a Vmux unit to the Network Management Station:
1. Connect the Network Management Station to the LAN (hub or switch).
2. Connect one of the Vmux’s Ethernet network (ETH-NET) ports to the LAN.
4.3 Configuring the Network Management Station
Before you can configure the circuits in RADview-SC/Vmux, you must first use the
SNMPc Management Console to:
• Launch the SNMPc Management Console
• Create the Vmux nodes
• Define the Manager List
• Read the Configuration
Launching the SNMPc Management Console
The SNMPc Management Console is used to create and configure the network
nodes, so that the devices are available for management in the RADview Service
Center. Before you can create and manage the network nodes, you must first
launch the SNMPc Management Console.
 To launch the SNMPc Management Console:
• From the Windows Start menu, select All Programs > Network Manager >
RADview 32.