System information

User's Manual Chapter 4 Configuring a Typical Application

Vmux-210 Ver. 1.0 Configuring the Vmux Units for Management 4-3

Configuring the Host IP Settings

1. Display the Host IP menu (Configuration > System > Management > Host IP).

2. Enter the IP address, subnet mask and default gateway values, according to

the parameters in the following table:

Table 4-1. Typical Application - Host IP Settings

Site Device Type IP Address Subnet Mask Gateway

A Vmux-2100 172.17.158.11 255.255.255.0 172.17.158.1

B Vmux-210 172.17.158.9 255.255.255.0 172.17.158.1

C Vmux-110 172.17.158.14 255.255.255.0 172.17.158.1

If they are enabled, you must first disable the router and DHCP in order to

manually configure the host IP settings of Vmux-110 and 210. Vmux-2100 does

not contain a router.

3. Enter the SNMP values for: read, write, and trap communities, according to

the parameters in the following table:

Table 4-2. Typical Application - SNMP Settings

Read Community Write Community Trap

public Private Public

4. Save the changes to the configuration database, by pressing @ (Shift+2).

Configuring the Manager List

1. Display the Manager List menu (Configuration > System > Management >

Manager List).

2. Set the manager IP Address to 172.17.158.12. If your Network Management

Station (NMS/Manager) has a different IP address, substitute the correct IP

address of your NMS.

If your Network Management Station (NMS/Manager) has a different IP address,

substitute the correct IP address of your NMS.

3. Save the changes to the configuration database, by pressing @ (Shift+2).

Not

Note