System information

Chapter 3 Configuration Management User's Manual
3-46 Additional Tasks Vmux-210 Ver. 1.0
Resetting Vmux-210 to the Default Configuration
The Reset Configuration command enables you to reset the Agent’s configuration
back to the factory defaults. Use this command when you wish to reconfigure all
of the parameters from a clean starting point. This is useful when Vmux-210's
current configuration is completely unsatisfactory, such as when moving a device
to another site, or if the configuration database has become corrupted or the
device's software has been upgraded.
 To reset the configuration:
1. In Agent mode only, select the device.
2. From the Configuration menu, select System Commands >
Reset Configuration.
3. Click <OK>.
The hardware configuration is reset.
Figure 3-30. Reset Configuration Dialog Box
Polling the Agent
The Poll Agent command causes the device to immediately poll the Agent. This
command is useful if you configure the device NOT to perform periodic polling of
the Agent. Using this command, you can perform a ‘one time’ polling to update
the device’s status.
 To poll the Agent:
1. In either Agent or Edit mode, select the device.
2. From the Configuration menu, select System Commands > Poll Agent.
The device immediately polls the agent.