System information

ManualsBrandsRAD Data comm ManualsComputer equipmentVmux-210

Chapter 3 Configuration Management User's Manual

3-42 Additional Tasks Vmux-210 Ver. 1.0

Table 3-25. Bundle Connection Details SW Cfg 5 Connection Parameters

Parameter Possible Values/Remarks

VAD Method The voice activation detection (VAD) method

Proprietary, Internal (ITU-T)

Default: Proprietary

Note:

• Proprietary uses a non standard VAD method, based only on power measurement. This

method is very sensitive to background noise.

• Internal (ITUT) uses the standard ITU-T method for VAD. This method is very robust.

Tx Gain (dB) The transmit gain, in dBm.

-6..6

Default: 0

Note:

• This parameter is disabled for FXS/FXO/E&M bundles.

•

In the CLI, this parameter is called Volume (To Line).

Rx Gain (dB) The receive gain, in dBm.

-6..6

Default: 0

Note: In the CLI, this parameter is called Volume (From Line).

Caller ID Type The Caller ID type used by the DSP for this bundle

Bellcore Type 1, V.23

Default: Bellcore Type 1

Note:

• Bellcore type Caller ID is the American method.

• V.23 type Caller ID is the European method.

• This parameter is only available when Voice Coding is set to G729A 8.

VBD Rate

(kbps)

The voice-band data (VBD) rate for this bundle

64 in 5 msec Intervals (G.711), 64 in 10 msec Intervals (G.711), 32 (G.726), 24 (G.726)

Default: 64 in 5 msec Intervals (G.711)

CAS

Redundancy

Enables or disables CAS signaling redundancy

Disable, Enable

Default: Disable

Note

•

Enable means that each packet containing CAS signaling will be replicated, for

redundancy, into 3 packets. This setting is useful when there are problems with the

network. This parameter only affects connections that utilize CAS signaling, such as:

E1-MF (G.732S) or E1-CRC-MF (G.732SCRC ).

•

Disable means that no redundancy will exist. Only 1 packet containing CAS will be

transmitted.

Advanced Voice

Parameters…

Click <Advanced Voice Parameters…> to open the Advanced Voice Parameters dialog box

and display additional voice parameters.

[Close] Click <Close> to close the dialog box.

[Refresh] Click <Refresh> to refresh the data displayed in the dialog box.