System information

User's Manual Chapter 3 Configuration Management
Vmux-210 Ver. 1.0 Additional Tasks 3-37
Table 3-22. Bundle Connection Details SW Cfg 2 Connection Parameters (Cont.)
Parameter Possible Values/Remarks
Modem Disable, Voice Band Data, Relay
Max VBD Modem Calls Maximum number of voice-band data (VBD) modem calls for this bundle
Channel E1: 1..31
Channel T1: 1..24
Analog Voice: 1..30
Max Relay Modem Calls Maximum number of relay modem calls for this bundle
Channel E1: 1..62
Channel T1: 1..48
Analog Voice: 1..30
Echo Canceller Disable, Enable
Caller ID Tx Delay
(msec)
0..3000 (in steps of 100)
Default: 400
Note: In the CLI (ASCII terminal), this parameter is called CLID Tx Delay.
This parameter is enabled only when Voice Coding is set to G729A 8 KBPS.
Noise Level for VAD Defines the level of noise on the line, that the Voice Activation Detector (VAD) will
have to handle
Low, High, Off
Default: Low
Note:
• High optimizes the VAD for environments where background voice as well as
background noise must be carried across the link (such as in environments
where conference bridges and speaker phones are used).
• Low reduces the background noise passed across the link (and therefore
reduces the bandwidth consumed).
• Off is only available when Voice Coding is not set to:
G711 A Law or G711 u Law.
Comfort Noise
Generation
Off, On
Default: On
[Close] Click <Close> to close the dialog box.
[Refresh] Click <Refresh> to refresh the data displayed in the dialog box.