System information
Chapter 3 Configuration Management User's Manual
3-28 Additional Tasks Vmux-210 Ver. 1.0
Table 3-17. FXS Status Parameters
Parameter Possible Values / Remarks
Port Port Name
Connected Yes, No
Bundle No. --, 1.. 12/15/24/30
State
(Agent mode
only)
--, On Hook, Off Hook
[Close] Click <Close> to close the FXS Status dialog box
Displaying Link E1/T1 Port Time Slot Assignments
The TS Assignment… command enables you to display time slot assignments for
IP bundles. Time Slot Assignments for FXS ports are accessed through the System
Level Configuration menu. Time Slot Assignments for E1 and T1 ports are
accessed through the Port Level Configuration menu. For information on creating
and managing bundle connections and time slots using the Service Center, refer
to
Chapter 7
of the
RADview SC/Vmux System Manual
.
•
Perform a Read before opening the TS Assignment dialog box, to ensure that
the most up-to-date information is displayed. The Read command is described
in
Reading (Uploading) the Agent Configuration, page 3-43.
•
For Link E1/T1 ports when Line Type is set to Unframed, Time Slot Assignment
is not relevant and the menu is unavailable. Unframed E1/T1 Ports are treated
like a pipe of 2 Mbps.
•
You should assign which Time Slots to use according to the bandwidth
allocated from the carrier. For example: if the available bandwidth is 128 kbps,
then you should select two Time Slots of 64 kbps each. The carrier may also
require certain Time Slot numbers. Vmux-210 uses all of the Time Slots that
you define.
To display configure time slot assignments for a Link E1/T1 Port:
1. In either Agent or Edit mode, select the Link E1 or Link T1 port.
2. From the Configuration menu, select TS Assignment….
The TS Assignment dialog box appears, displaying IP Bundle Connections.
Each Bundle Connection contains the Time Slots numbers of the bundle
and their Destination Time Slots numbers.
Figure 3-19. TS Assignment Dialog Box Box – Link E1/Link T1 Port
Note