System information

User's Manual Chapter 3 Configuration Management
Vmux-210 Ver. 1.0 Setting the Operational Parameters 3-25
Table 3-14. Serial Link SW Cfg Tab Parameters (Cont.)
Parameter Possible Values / Remarks
Loop Detect Enables/disables Loop Detection on the Serial Uplink
Disable, Enable
Default: Disable
Note: This parameter is disabled when HDLC Mode is set to Cisco Bridged ETH.
[Set] Click <Set> to reset the new values in the dialog box
[Cancel] Click <Cancel> to cancel the selections made in the dialog box and close the
box
[Close] Click <Close> to close the dialog box
[Refresh] Click <Refresh> to refresh the data in the dialog box
Copying a Port Configuration
In order to save time and trouble, once a port is configured, its software
configuration can be easily copied to other ports, using the port Copy command.
 To copy a port configuration to another port:
1. In Edit Mode, select an FXS Port.
2. From the Configuration menu, select Copy….
3. Click a destination port to select it.
Or
To select multiple destination ports, hold down the Control (Ctrl) key and click
the desired destination ports.
4. If a confirmation dialog box appears, click <OK> to confirm that you want to
copy any way and replace the existing port configurations.
The configuration is copied from the selected source port to the selected
destination ports.
Figure 3-16. Port Copy Dialog Box