System information

User's Manual Chapter 3 Configuration Management
Vmux-210 Ver. 1.0 Setting the Operational Parameters 3-23
Table 3-12. Link T1 SW Cfg Tab Parameters (Cont.)
Parameter Possible Values / Remarks
HDLC Mode Transparent, Cisco Bridged ETH
Default: Transparent
Loop Detect Enables/disables Loop Detection on the TDM Uplink
Disable, Enable
Default: Disable
Note: This parameter is disabled when HDLC Mode is set to Cisco Bridged ETH.
[Set] Click <Set> to reset the new values in the dialog box
[Cancel] Click <Cancel> to cancel the selections made in the dialog box and close the box
[Close] Click <Close> to close the dialog box
[Refresh] Click <Refresh> to refresh the data in the dialog box
Analog Voice Port Software Configuration
Figure 3-14. Analog Voice Port SW Cfg Tab
Table 3-13. Analog Voice Port SW Cfg Tab Parameters
Parameter Possible Values / Remarks
Port FXS-1..FXS-30
Tx Gain (dB) The selected attenuation value brings your signal level closer to the expected
repeater signal level on the cable.
FXS: -4..5
Default: 0
Rx Gain (dB) FXS: -10..5 (Default: -4)
[Set] Click <Set> to reset the new values in the dialog box
[Cancel] Click <Cancel> to cancel the selections made in the dialog box and close the box
[Close] Click <Close> to close the dialog box
[Refresh] Click <Refresh> to refresh the data in the dialog box