System information

Chapter 3 Configuration Management User's Manual
3-20 Setting the Operational Parameters Vmux-210 Ver. 1.0
Table 3-11. Link E1Port SW Cfg Tab Parameters
Parameter Possible Values / Remarks
Port Link E1
Connect Indicates whether the port should be considered in any of the Vmux algorithms
No, Yes
Default: No
Line Type The line type of the interface
E1 (G.732N), E1-CRC (G.732NCRC), E1-MF (G.732S),
E1-CRC-MF (G.732SCRC), Unframed
Default: E1 (G.732N)
Restore Time The time required to restore normal service after the end of a loss of
synchronization condition
FAST, TR-62411, CCITT G.732
Default: FAST
Note: This parameter is disabled when the Line Type is set to Unframed.
Clock Mode Defines the clock operation mode of the interface
LBT (loop back timing), Internal, LBT from Channel
Default: LBT
Interface Type Interface type
DSU, LTU
Default: DSU
Line Impedance Unbalanced (75 Ohm), Balanced (120 Ohm)
Default: Balanced
Idle Code (hex) Hexadecimal code transmitted to fill idle (unused) time slots in frames transmitted
through the selected port
00..FF
Default: FF
Note: The following values are not allowed:
0H, 8H, 10H, 12H, 21H, 24H, 42H, 49H, 84H, 92H
Fragmentation (Bytes) 200…610…1550
Default: 610
HDLC Mode Transparent, Cisco Bridged ETH
Default: Transparent
Loop Detect Enables/disables Loop Detection on the TDM Uplink
Disable, Enable
Default: Disable
Note: This parameter is disabled when HDLC Mode is set to Cisco Bridged ETH.
[Set] Click <Set> to save the new values in the dialog box
[Cancel] Click <Cancel> to cancel the selections made in the dialog box and close the box
[Close] Click <Close> to close the dialog box
[Refresh] Click <Refresh> to refresh the data in the dialog box