System information
Chapter 3 Configuration Management User's Manual
3-18 Setting the Operational Parameters Vmux-210 Ver. 1.0
Table 3-10. ETH Port SW Cfg Tab Parameters
Parameter Possible Values / Remarks
Port ETH-NET, ETH-USER
Physical Address
(Agent Mode only)
MAC Address - 6 Octets
Auto Negotiation Whether Auto Negotiation is enabled
Default: Enabled
Max Capability
Advertised
10BASE-T (Half Duplex)
10BASE-T (Full Duplex)
100BASE-TX (Half Duplex)
100BASE-TX (Full Duplex)
Default: 100BASE-TX (Full Duplex)
Default Type Defines the rate and duplex mode of an ETHERNET port
Applicable only when Auto Negotiation is disabled
10BASE-T (Half Duplex)
10BASE-T (Full Duplex)
100BASE-TX (Half Duplex)
100BASE-TX (Full Duplex)
Default: 100BASE-TX (Full Duplex)
Input Rate Limit (kbps) Disabled, 128, 256, 512, 1024, 2048, 4096, 8192
Default: Disabled
[Set] Click <Set> to save the new values in the Port Information dialog box
[Cancel] Click <Cancel> to cancel the selections made in the dialog box and close the box
[Close] Click <Close> to close the Port Information dialog box
[Refresh] Click <Refresh> to refresh the data in the Port Information dialog box