System information

Chapter 3 Configuration Management User's Manual
3-12 Setting the Operational Parameters Vmux-210 Ver. 1.0
You can add up to ten entries.
Figure 3-8. Add VLAN Entry Dialog Box
Changing an Entry in the VLAN Table
 To reconfigure an entry in the VLAN table:
1. In the VLAN Table dialog box, select an entry from the VLAN Table and click
<Change>.
2. Configure the desired parameters in the Change VLAN dialog box (see
Table 3-7 ).
3. Click <Set> to save the new values and return to the VLAN Table dialog box.
A confirmation dialog box appears.
4. Click <OK> to save the changed values and return to the VLAN Table dialog
box.
Removing an Entry from the VLAN Table
 To remove an entry from the VLAN table:
1. Select an entry from the VLAN Table.
2. Click <Remove>.
Configuring FXS Timeouts and Cadences
The Timeouts & Cadences… command enables you to configure timeout and
cadence values for a specific FXS port. The ringer cadences determine the lengths
of the ring tones and the silences in between. Use the FXS Timeouts and
Cadences dialog box to configure the on/off timing characteristics of the ring
signal, as well as the ring and flash timeouts, to match the local standards or to
provide a custom ring signal for the line.
Note