System information

User's Manual Chapter 3 Configuration Management
Vmux-210 Ver. 1.0 Setting the Operational Parameters 3-11
Table 3-7. VLAN Table Parameters
Parameter Possible Values / Remarks
VLAN ID 1..4094
Default: 1
ETH-Net Transparent – This port transmits egress packets for this port as unmodified
Forbidden – This port is prohibited from being included in the egress list for this
VLAN
Untagged – This port transmits egress packets for this VLAN as untagged
Tagged – This port transmits egress packets for this port as tagged
Default: Forbidden
ETH-User Transparent – This port transmits egress packets for this port as unmodified
Forbidden – This port is prohibited from being included in the egress list for this
VLAN
Untagged – This port transmits egress packets for this VLAN as untagged
Tagged – This port transmits egress packets for this port as tagged
Default: Forbidden
Link Mng OR
Channel Mng
(available if Connect
Through is Link E1/T1
or Serial Port)
Transparent – This port transmits egress packets for this port as unmodified
Forbidden – This port is prohibited from being included in the egress list for this
VLAN
Untagged – This port transmits egress packets for this VLAN as untagged
Tagged – This port transmits egress packets for this port as tagged
Default: Forbidden
[Add] Click <Add> to add an entry to the VLAN table.
[Change] Click <Change> to change the parameter values of an entry in the VLAN table.
[Remove] Click <Remove> to remove an entry from the VLAN table.
[Apply]
(in Add VLAN table
only)
Click <Apply> to save new parameter values and add an entry to the VLAN table.
[Set]
(in Change VLAN
table only)
Click <Set> to save new parameter values for an entry in the VLAN table.
[Close] Click <Close> to close the dialog box.
Adding an Entry to the VLAN Table
 To add an entry to the VLAN table:
1. In Edit mode, in the VLAN Table dialog box, click <Add>.
2. Configure the desired parameters in the Add VLAN dialog box (see the
following table).
3. Click <Apply> to save the new values.
4. Click <Close> to close the Add VLAN dialog box and return to the VLAN Table
dialog box.