System information

Chapter 3 Configuration Management User's Manual
3-10 Setting the Operational Parameters Vmux-210 Ver. 1.0
The Link/Channel+ Mng tab is only enabled when the router is disabled.
Configuring the VLAN Table
The VLAN Table command enables you to configure the list of virtual LANs
(VLANs). A VLAN is a logical (virtual) network of devices that behave as if they are
on the same physical LAN segment, even if they are physically connected to
different network segments. In addition, multiple VLANs can co-exist on the same
switching hardware, providing a form of logical network segmentation.
The VLAN Table is unavailable when either of the following is true:
• The router is enabled, the Net/User Routing Mode is Layer 3 Routing, and the
Connect Through value is Serial Link or Link E1/T1.
• The router is enabled and the Connect Through value is ETH-NET.
 To view the VLAN Table:
1. In Agent mode (for viewing) or Edit mode (for setting), select the device.
2. From the Configuration menu, select VLAN Table.
Figure 3-7. VLAN Table – Edit Mode
Note
Not
e