System information

User's Manual Chapter 3 Configuration Management
Vmux-210 Ver. 1.0 Setting the System Parameters 3-5
Some configuration selections may produce a second, confirmation dialog box to
verify the configuration settings.
If you receive the following error message:
“Cannot change Link Type. Link TSA and/or Voice Bundles exist. Removing them
can be done only via the Service Center.”
• In order to remove a Link TSA via the Service Center:
In the Service Center, from the Channel List, click <Remove>.
• In order to remove a Voice Bundle via the Service Center:
In the Service Center, from the Circuit List or the Channel Circuit List, click
<Remove>.
Figure 3-3. System Parameters Dialog Box – Agent Mode
Table 3-3. System Parameters
Parameter Possible Values/Remarks
Connect Through ETH-NET, Serial Link, Link E1/T1
Default: Serial Link
Note: In the CLI (ASCII terminal) this parameter is called “Main Link”.
Router Note: The router function is NOT supported in this version of RADview.
Enable Checked, Unchecked
Default: Unchecked
Net/User Routing Mode
(enabled only when
Router is Enabled and
Connect Through is Serial
Link or Link E1/T1)
Layer 2 Switching, Layer 3 Routing
Default: Layer 2 Switching
Note: When Router is enabled and Connect Through is ETH, then Net/User
Routing Mode is Layer 3 Routing.
Default Gateway
(enabled only if Router is
enabled (Enable is
checked))
The IP address of the next hop
0.0.0.0–255.255.255.255
Default: 0.0.0.0 (Router Default Gateway is disabled)
[Set] Click <Set> to save System Parameters settings
[Cancel] Click <Cancel> to cancel the selections made in the dialog box and close the box
Note