System information

Chapter 3 Configuration Management User's Manual
3-4 Setting the System Parameters Vmux-210 Ver. 1.0
Figure 3-2. Port User Info Dialog Box
Table 3-2. Port User Info Parameters
Parameter Possible Values / Remarks
Port For ETH port: ETH-NET, ETH-USER
For E1 port: Link E1
For T1 port: Link T1
For FXS port: FXS-1, …, FXS-30
For Serial Link port: Serial Link
User Name User supplied name whose maximum length is 15 characters
User Info User supplied information whose maximum length is 70 characters
[Set] Click <Set> to send new values to the agent
[Cancel] Click <Cancel> to cancel the selections made in the dialog box and close the box
Configuring System Parameters
The System Parameters command enables you to view and set major system
parameters for the Vmux-210 device. You can configure parameters such as
whether the device contains an E1 or T1 port, and which port should be used as
the "connect through" or "main link" port. The router function is not supported in
the version of RADview.
 To view and set system parameters:
1. In Agent mode (for viewing) or Edit mode (for setting), select the device.
2. From the Configuration menu, select System Parameters.
3. Configure the desired parameters and click <Set>.