System information

Chapter 2 Installation and Operation User's Manual
2-4 Launching RADview Vmux-210 Vmux-210 Ver. 1.0
2.2 Connecting Vmux-210 to the Management
Station
Vmux-210 can be managed by a Network Management Station (NMS) that is
located on the LAN (hub or switch) connected to the one of the unit’s Ethernet
ports.
 To connect Vmux-210 to the Network Management Station:
1. Connect a Network Management Station to the LAN (hub or switch).
2. Connect one of the Vmux-210 Ethernet ports to the LAN.
Normally, Vmux-210 management is performed out-of-band, via the USER port.
To enable in-band management via the NET port, you may need to configure
additional parameters.
2.3 Launching RADview Vmux-210
To monitor and manage the Vmux-210 device using the RADview Vmux-210
Element Manager application, it must first be opened or launched. The Element
Manager can be opened from the SNMPc Management Console (PC version) or
from HPOV (Unix version). A separate RADview Vmux-210 Element Manager
window can be opened for each Vmux-210 unit.
 To open the Vmux-210 Element Manager from the SNMPc Management Console
window (PC version):
• Double-click the Vmux-210 icon located in the map view.
The RADview Vmux-210 Element Manager window appears
(see
Figure 2-3 ).
 To open the Vmux-210 Element Manager from the HPOV window (Unix version):
• Select the Vmux-210 icon located in the map view and then click the zoom
icon (
).
The RADview Vmux-210 Element Manager window appears
(see
Figure 2-3 ).
Note