System information

Chapter 7 Fault Management User’s Manual
7-20 Running Loopback Tests Vmux-210 Ver. 1.0
 To run a test on a port:
1. In Agent mode, select a port.
2. From the Diagnostics menu, select Test.
or
From the toolbar, click
.
3. From the Test drop down list, select the desired test.
If you want to enable per time slot testing,
select Test per TS and then select the desired time slots.
4. Configure the desired test parameters.
5. Click <Start Test> to begin testing.
6. When you are finished testing, be sure to click <Stop Test> to return the port
to normal operation.
Figure 7-13. Test Dialog Box for E1/T1 Ports (with Time Slots)
Figure 7-14. Test Dialog Box for Analog Voice (FXS) Ports (without Time Slots)