System information

User’s Manual Chapter 7 Fault Management
Vmux-210 Ver. 1.0 Monitoring Object Status 7-3
Table 7-1. Mux All Active Alarm List Parameters
Parameter Possible Values / Remarks
Code Alarm code
Port Selected port, if applicable
Description Description of the alarm
Severity No Report, Event, Minor, Major, Warning, Critical
State On, Off
Mask Mask, None
Counter Number of times this alarm has been triggered since the last time the system was
restarted or the alarm was cleared.
[Print] Click <Print> to print the Mux All Active Alarm List.
This button is disabled if the table is empty.
[Save to File] Click <Save to File> to save the Mux All Active Alarm List. The Save File dialog box
appears. In the File Name field, enter the name of the file. In the File of type field, select
Acrobat (*pdf) or HTML (*.htm). Click Save.
This button is disabled if the table is empty.
[Clear All] Click <Clear All> to clear all active alarms of all levels and close the Mux All Active Alarm
list.
This button is disabled if the table is empty.
[Close] Click <Close> to close the Mux All Active Alarm List dialog box
[Refresh] Click <Refresh> to update the Mux All Active Alarm List
Viewing System Level Active Alarms
The Display > System Level command enables you to view system level alarms.
 To view system level Active Alarms:
1. In Agent mode only, select the device.
2. From the Fault menu, select Alarms > Display > System Level.
As the list of alarms is prepared, a Progress Bar window illustrates the
upload progress. If no alarms exist, the list will be empty.
3. Sort the list of alarms by any one of the column values by clicking on the
column header. Each click toggles between ascending and descending order.