System information

Vmux-210 Ver. 1.0 Pre-configuring Vmux-210 for Network Management 2-1
Chapter 2
Installation and Operation
This chapter describes how to configure Vmux-210 for management and explains
how to perform the following tasks:
• Pre-configuring Vmux-210 for Network Management
• Connecting Vmux-210 to the Management Station
• Launching RADview Vmux-210
• Using the Graphical User Interface
2.1 Pre-configuring Vmux-210 for Network
Management
To remotely administer Vmux-210 via a Network Management Station (NMS), it is
necessary to first configure some basic Vmux-210 parameters via an ASCII
terminal. The following steps are required:
1. Connecting a Terminal to the Control Port
2. Disabling the Router
3. Configuring the host IP parameters (IP address, IP mask, default gateway,
SNMP Communities)
4. Defining the Network Management Station in the Manager List.
For more detailed information about configuring Vmux-210 for Network
Management, see
Chapter 4 of the Vmux-210 Installation and Operation Manual .
Connecting a Terminal to the Control Port
In order to configure the basic IP parameters, it is necessary to connect an ASCII
terminal to the Vmux-210 control port and log in.
 To configure the Vmux-210 system parameters:
1. Configure an ASCII terminal to:
 One start bit
 Eight data bits
 No parity
 One stop bit
 No flow control
 VT100 emulation.