Specifications

Chapter 4 Configuration Installation and Operation Manual
4-24 Configuring for Operation Vmux-210 Ver. 1.1
Table 4-24. VLAN Parameters
Parameter Description Possible Values/
Reference
VLAN Tagging Whether all frames of this bundle should
contain a VLAN tag
Yes
No
Default: No
VLAN ID VLAN ID number in the tag added to frames
of this bundle
Note: This parameter is available only when
VLAN Tagging is set to Yes.
26..4094
Default: 26
Priority Tag VLAN priority in the tag added to frames of
this bundle
Note: This parameter is available only when
VLAN Tagging is set to Yes.
0..7
Default: 0
Configuring a Bundle’s Connectivity Parameters
 To configure a bundle’s connectivity parameters:
• From the Main Menu, select Configuration > Bundles > Configure >
Edit Bundle > Connectivity Parameters.
Connectivity Parameters
1. Connectivity Mode> (With Ping)
2. Connectivity Packet Rate (sec)[1 - 60]... (5)
3. Connectivity Timeout Cycles[1 - 5]... (2)
Figure 4-25. Connectivity Parameters Menu
Table 4-25. Connectivity Parameters
Parameter Description Possible Values/
Reference
Connectivity Mode Method of determining a bundle’s
connectivity state
With Ping
Without Ping
Default: With Ping
Connectivity Packet
Rate (sec)
Rate of connectivity packets for this bundle 1..60
Default: 60
Connectivity
Timeout Cycles
Number of times the Vmux-210 tries to
transmit connectivity frames for this bundle
before timing out
1..5
Default: 3
The Vmux at the remote end of this bundle must use the same connectivity
mode.
Note