Specifications

Chapter 4 Configuration Installation and Operation Manual
4-4 Configuring for Management Vmux-210 Ver. 1.1
Setting Host IP Parameters
 To set the Host IP parameters:
• From the Main Menu, select Configuration > System > Management > Host IP.
Host IP
1. IP Address... (172.17.172.191)
2. Subnet Mask... (255.255.255.0)
3. Default Gateway... (172.17.172.1)
4. DHCP Client (Disable)
5. Read... (public)
6. Write... (private)
7. Trap... (public)
Figure 4-3. Host IP Menu
Table 4-3. Host IP Parameters
Parameter Description Possible Values/
Reference
IP Address Vmux-210’s IP address
Note: Only available when Router is disabled.
Default: 0.0.0.0
Subnet Mask Vmux-210’s subnet mask
Note: Only available when Router is disabled.
Default: 0.0.0.0
Default Gateway Vmux-210’s default gateway
Note: Only available when Router is disabled.
Default: 0.0.0.0
DHCP Client Enables DHCP client for obtaining IP
addresses
Enable
Disable
Default: Disable
Read Read Community for SNMP Default: public
Write Write Community for SNMP Default: private
Trap Trap Community for SNMP Default: public
Configuring the Manager List
You can define the network management stations to which the SNMP agent of
the Vmux-210 will send traps. You can define up to ten managers. In addition,
you can configure Vmux-210 to accept Telnet/Web management traffic only from
the management stations defined in the Manager List.