Specifications

Installation and Operation Manual Chapter 3 Operation
Vmux-210 Ver. 1.1 Default Settings 3-5
Table 3-3. Physical Port Default Settings (Cont.)
Parameter Default Value
Configuration > Physical Ports > Analog > Ringer Profiles
Period #1: Ring (x 100 msec) 10
Period #1: Silence (x 100 msec) 30
Period #2: Ring (x 100 msec) 0
Period #2: Silence (x 100 msec) 0
Configuration > Physical Ports > Analog > Gains
Tx Gain (dB) 0
Rx Gain (dB) -4
Configuration > Bundles > Configure
Bundles No bundles defined
Configuration > Bundles > Configure > Edit Bundle > Routing Parameters
Destination IP 0.0.0.0
Destination Bundle 1
TOS Byte 0x00
Configuration > Bundles > Configure > Edit Bundle > Routing Parameters > VLAN
Parameters
VLAN Tagging No
Configuration > Bundles > Configure > Edit Bundle > Connectivity Parameters
Connectivity Mode With Ping
Connectivity Packet Rate (sec) 60
Connectivity Timeout Cycles 3
Configuration > Bundles > Configure > Edit Bundle > Voice Parameters
Coder/Rate G.723.1/6.4
Noise Level for VAD Low
Echo Canceller Enable
Caller ID Tx Delay (mSec) 400
Configuration > Bundles > Configure > Edit Bundle > Voice Parameters >
Fax/Modem
Modem Modem Relay
Fax Enable
Fax Rate (kbps) 14.4
Configuration > Bundles > Configure > Edit Bundle > Signaling Parameters
Ringback Enable
Reverse Polarity Disable
Pulse Metering Disable