Specifications

Quick Start Guide Installation and Operation Manual
2 Configuring Vmux-210 Vmux-210 Ver. 1.1
2. Configuring Vmux-210
Configure Vmux-210 to the desired operation mode via an ASCII terminal connected
to the rear panel CONTROL port. Alternatively, you can manage Vmux-210 over
Telnet.
Starting a Terminal Session for the First Time
 To start a terminal session:
1. Connect a terminal to the CONTROL connector of Vmux-210.
2. Turn on the control terminal PC and set its port parameters the default
communication parameters:
 One start bit
 Eight data bits
 No parity
 One stop bit
 No flow control
 VT100 emulation (for optimal view of system menus).
3. Power up Vmux-210.
4. After the boot sequence (approximately 50 seconds), press <Enter> several
times.
The rate is detected automatically.
5. Proceed with the management session.
Configuring Basic Parameters
The host IP address, subnet mask and default gateway IP address must be
configured via an ASCII terminal.
 To configure basic parameters:
1. From the Main Menu, select Configuration > Quick Setup.
The Quick Setup menu appears (see
Figure 1 ).
2. Configure the desired parameters (see
Table 1 ).
3. Select Save.
4. Type ‘@’ and press <Enter>.
The following message is displayed:
Are you sure you want to update data base?
Press Y/N :